Isolierglasherstellungsmaschine

lisec Inspection Lightwall

1. Switch on the wall and the electronics.
Do this by switchting on the mean switch and the lightwall (on the back). Also switch on the multimeters. See photos 1 and 2
2. Adjust the upper- and lowerbeam to the right cellheight. Do this with 2 people. See photo 3
3. Check if there is no power on the cables coming from the power beam. Use for this the multimeters.
4. Connect the cells with the cables.
5. Check the cells with the protocol“Q3 quality finished cell”.
6. Use the right voltages for the different products. 24V for ddLC and 46V for scatter.
7. When doing the capacity measurement, turn the black switching knob from „power“ to „R/C“. When done turn it back to „power“
8. When you have ddLC cells use the lightwall and the rotatable polar.
9. If you have scatter cells remove the lightwall and use the spotlight. For swtiching on/of this spotlight you can use the remote control. See photo 4.
10. When you are done, please use the mainswitch to power down, and switch of the used lights.
Dksdpov Ep U Ajfx Ah Rou